Main

Shipping

Returns

Devices

Downloads

About


Video Games

Pinball Machines

All Other Programming

Technical Resources

Prices and Ordering

Chip Reference

Disclaimer

Arcade Archive DVDs

Removing and Installing an EPROM

Removing your old EPROM and installing a new one is very easy and takes only a couple of minutes and a small, flat head screwdriver.

Before Installing or Removing EPROMs
Be sure to turn off the power, and unplug the power cord from the wall outlet. Static electricity can damage EPROMs. To avoid this, touch some metal part of your game before handling the EPROMs. DO NOT remove EPROMs from the anti-static foam until you're ready to install them.

Removing EPROMs
Insert the blade of the screwdriver between the EPROM and the socket, close to one row of pins. Be sure you aren't prying the socket itself. GENTLY twist the screwdriver to lift the row of pins a fraction of an inch, then continue doing this to the other end of the EPROM and keep doing all 4 corners slowly until the EPROM pops out.

Removing An Eprom

Installing EPROMs
Align the chip with the empty socket. Both the chip and the socket have a small notch on one end; align the chip so that its notch matches up with the notch on the socket. If you have problems finding the notch on the socket, just make sure that the notch on the chip to be inserted faces the same direction as the notches on the other chips near the chip(s) being inserted.

Before installing a chip, verify that its pins match up with the holes in the socket. If they don't, align the pins by laying the chip on its side on a table and gently pressing its top edge of the EPROM (not the pins) so as to bend the pins only slightly inwards. Repeat for the other row of pins if necessary. DO NOT use excessive force while doing this or you may damage the eprom by breaking legs off.

Make sure the new EPROM you insert has the same name and sequence number as the EPROM you are replacing. Example:Replace a 2732 EPROM with another 2732 EPROM. When you are sure the pins are aligned correctly, press firmly and evenly on the chip to seat the pins in the socket.

Carefully examine the pins of the chip and look for any pins that are bent under or out. If you find bent pins, remove the chip, gently straighten them, and restart the chip installation procedures again.

If you have any questions with this procedure it is always better to email me first.